Vroma Brushed Gold Rolled Stainless Steel 304 Self Adhesive 3 Meters

Brushed Gold is a gold colour with a smooth brushing effect and a satin finish.

Important Notes for Vroma Rolled Stainless Steel 304 Decorative Self-Adhesive Sheet

Non-Return Policy:

• No Returns Once Unrolled: Once the seal holding the stainless steel sheet in a roll is broken, we cannot accept returns. This policy is in place because the material can become deformed if it is re-rolled after unrolling, compromising its quality and appearance.

Important Installation Considerations:

1. Avoid Repositioning:
   • Once the sheet is adhered to a surface, it is important not to remove and reapply it. If the sheet is pulled up after initial application, it may not adhere smoothly again, leading to an uneven or compromised finish.
2. Accurate Measurement:
   • To avoid the need for repositioning, ensure that you measure the installation area accurately and cut the sheet to the correct size before removing the backing and applying it.

Installation Guide for Vroma Rolled Stainless Steel 304 Decorative Self-Adhesive Sheet

Caution:

• Sharp Edges: The edges of the stainless steel sheet are sharp. Please wear protective gloves while handling and unpacking the sheet to avoid injuries.

Materials and Tools Needed:

• Protective gloves
• Measuring tape
• Pencil
• Stainless Steel Sheet Scissors or a metal cutting tool
• Clean rag
• Hair dryer (optional for enhanced adhesion)

Step 1: Preparing the Surface

1. Clean the Surface:
   • Use a clean rag to thoroughly wipe down the wall or surface where the sheet will be applied. Ensure the area is free of dust, dirt, and moisture for optimal adhesion.
2. Measure and Mark:
   • Measure the area you wish to cover using a measuring tape. Mark the dimensions with a pencil on the wall to guide the application.
   • Cut the stainless steel sheet to the required size using appropriate cutting tools, being cautious of the sharp edges.

Step 2: Applying the Adhesive Sheet

1. Peel Off Backing:
   • Slowly peel off the backing of the self-adhesive strip. Start from one end and proceed gradually as you apply the sheet.
2. Optional Preheating:
   • For better adhesion, use a hair dryer to gently warm the adhesive side of the sheet before application. This can help the adhesive bond more securely, especially in cooler environments.

Step 3: Application and Finalization

1. Apply the Sheet:
   • Carefully position the sheet along the marked area. Start at one end and smooth the sheet onto the wall, pressing firmly to avoid bubbles or wrinkles. Use a soft cloth or a roller to apply even pressure.
2. Ensure Full Adhesion:
   • Press the entire surface of the sheet firmly against the wall to ensure it is fully adhered. Pay special attention to the edges and corners.
3. Curing Time:
   • Allow the adhesive to set and cure by waiting 24 hours before exposing the sheet to any potential stress or handling.

By following these steps, you can achieve a clean and secure installation of your Vroma Rolled Stainless Steel 304 decorative sheet. Remember to handle the sheet carefully to avoid injury and to ensure a professional finish.

If you want to install it on wall coverings and wall stickers that are not suitable for sticking, such as peeling, powder falling, uneven or damp, you can use nail free adhesive to strengthen the adhesion.